|
| Conproco |
| Conproco Corporation products help the design professional and contractor create, recreate and preserve distinctive structures, using products for preservation and repair of concrete and stone, cement finishing and resurfacing, repair mortars, stains and finishes, protective coatings, exterior wall systems, base coats and water repellents. |
|
| |
| Repair Mortars |
Use |
| MIMIC |
Repair and Preservation |
 |
Conpro Set
Available in different sizes |
Vertical and Overhead |
|
| Concrete Repair and Preservation |
Use |
Conpro Weld 1 Gallon |
Surface Preparation |
|
Conproco One Shot 2C 50lb. |
Horizontal |
|
Conproco Accelerator 1 Gallon |
Accelerator |
|
| Exterior Wall Systems |
Use |
Conproco K-88 Admix |
Finishes |
|
Below-Grade Waterproofing |
Use |
Conpro Plug 10 Gallon Pail |
Negative Side |
|
| Iron Clad |
| Masonry cement is a blend of portland cement and finely ground limestone, combined with various process additions that enhance water retention, workability, board life and durability. They are manufactured to meet ASTM C91. These portland cement-based products are designed for making mortar as prescribed in ASTM C270 "Mortar for Unit Masonry." |
| Gray Portland Cement |
| Type I |
A general-purpose portland cement suitable for all uses where special properties of other types are not required; uses include pavements, sidewalks, reinforced concrete buildings, bridges, railway structures, tanks, reservoirs, culverts, water pipe and masonry units. |
Type II Sulfate Resistant |
Type II portland cement offers moderate heat of hydration and sulfate resistance, for applications where sulfates in ground waters and/or soils are higher than normal, or in mass concrete work where heat of hydration is a concern. |
TYPE III High Early Strength |
Type III portland cement provides high early strengths during concrete curing, allowing forms to be stripped earlier or the structure to be put into service quickly. |
| Gray Masonry Cement |
| Type N |
For normal masonry construction. |
| Type S |
For use in masonry structures that require more strength than a Type N. |
| Quikrete® |
| QUIKRETE® Commercial Grade Products are specifically formulated to meet your job-site applications requirements, such as working time, compressive strength and flexural strength, bond strength, workability and consistency. |
 |
QUIKRETE Mortar Mix 80lb |
A blend of masonry cement and graded sand , designed to meet ASTM C 270 for Type N Mortar. Just add water. |
 |
QUIKRETE Concrete Mix 80lb |
The original 4000 psi average compressive strength blend of portland cement, sand, and gravel or stone. Just add water. Use for any general concrete work. |
 |
QUIKRETE® Fast Set Concrete 50lb |
A special blend of cement with specifically graded fine & coarse aggregates. Sets in 20-30 minutes allowing time for mixing, pouring and finishing. Use at any thickness from 1 1/2" (3.8 cm) to 24" (61 cm). Exceeds the requirements of ASTM C 928 R-3. |
 |
Quikrete 5000 80lb |
A commercial grade blend of stone or gravel, sand and cement specially designed for higher early strength. Ideal for cold weather application.
Achieves 5000 psi after 28 days. |
 |
QUIKRETE Sand/Topping Mix 80lb |
Consists of a uniformly blended mixture of portland cement, grades sand and other approved ingredients. |
 |
QUIKRETE® Vinyl Concrete Patch 40lb |
A multi-purpose concrete repair material with strong adhesive properties. Trowels to a feather edge of 1/16" (1.6 mm). Made of a special blend of exterior grade vinyl resin, fine sand, and portland cement. Just add water. Available in gray and white. |
 |
QUIKRETE® Commercial Grade Permanent Blacktop Repair 60lb |
A permanent blacktop patch for patching holes or making large repairs in blacktop and asphalt surfaces. Doesn't require heating or mixing, pour directly out of bag. Can be formed and compacted. Use all year round in wet or dry areas. Can be used in hot or cold weather. |
| Also available are 8”, 10”, 12” Sauna Tubes and 4"x 5' Expansion Joint Strips. |
Do you have installation questions ?
Click here for helpful tips & techniques from Marshalltown.com |
We have the materials, supplies and know how
to get the job done.
Contact us today to discuss your latest project and ideas. |
Return to top
|
|
|
|
